Can you use 3 tab shingles for starter strip?

Can you use a regular shingle as a starter strip?

Some roofers simply take regular shingles, flip them upside down and nail them down as a starter course. … A better way to install a starter strip is to cut the tabs off a shingle and make sure the tar line is at the bottom edge closest to the edge of the roof.

How do I start my first row of shingles on my roof?

For the first row of shingles, called a starter course or strip, you cut the tabs off three-tab shingles and apply them with the self-sealing adhesive strip facing up along the eave. Make sure this row has a slight overhang (1/4 to 3/8 in.) beyond the drip edge.

Do you need starter shingles with a drip edge?

We don’t recommend installing a drip edge after your starter shingles. In fact, the proper order to follow should be your drip edge first, along with an underlayment such as an ice and water shield. Roofing felt should also go before installing starter shingles.

Do you need to remove plastic strip on shingles?

Because the cellophane strips have no effect on the performance of asphalt shingles, it’s fine to leave them in place as you install the shingles. In fact, the effort to remove them is unnecessary and just adds an extra step for the contractor.

IT IS IMPORTANT:  Frequent question: Which countries does Australia provide aid to?

How much should shingles overhang drip edge?

Shingles should not extend more than 3/4” (19 mm) past the drip edge. If shingles overhang the edge of the roof by more than 3/4” (19 mm), then they are not supported and may crack and break off. In addition, the wind resistance at the roof edge may be compromised.

Do you overlap starter shingles?

With the starter shingles laid along the very edge of the roof, run a set of starter shingles along the sides of the roof as well, making sure that those rows come down and overlap the starter shingles you laid at the bottom.